Samsung CS21S8 Spezifikationen PDF herunterladen (Seite 18)

Alignment and Adjustments

Samsung Electronics 4-5

4-8 Factory Adjustment

1. To enter the “Service Mode”, Press the remote-control keys in this sequence :

- If you do not have Factory remote-control

- If you have Factory remote-control

2. After the Service Mode is entered, the initial screen is as shown in the figure below.

xx xx xx

3. Use the Channel Up/Down buttons to move the cursor in the adjustment parameters.

Note :

- When CRT, CRT PCB, FBT, E

PROM (sometimes MICOM) is replaced, the adjustment values

should be controlled.

- After the Service adjustment is completed, Do not select “Reset” in the service mode menu.

(After above procedure is done, power is on initially and the “Plug and Play” will be operated.)

PICTURE OFF PICTURE ON

DISPLAY

()

MUTE

PICTURE ON

DISPLAY

()

FACTORY

4-8-1 Service Mode

These hexa digits are check sum value which

depends on the MICOM version.

If check sum value is changed, the value of

PROM Data newly initialed.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 64 65

Keine Kommentare

Samsung CS21S8 Spezifikationen Seite 18