Samsung RM25JGRS Bedienungsanleitung PDF herunterladen (Seite 33)

INSTALLATION INSTRUCTIONS

WATER

ICE

INSTALLATION OF THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line after installing filter.

1) Turn on the main water supply & shut-off the valve of the

water supply line.

2) Run water through the dispenser until the water runs clear

(6~7 minutes). This will clean the water supply system and

clear air from the lines.

3) Additional flushing may be required in some households.

4) Open the fridge door and check if water leaks around the

water filter.

•

A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.

NOTE

Check the amount of water supplied to the ice tray.

1) To remove : Set the type of ice to the “Ice Off” position. Lift up

(①) and pull out (➁) the ice bucket in the freezer.

To replace : When replacing the drawer, be sure to press it firm-

ly into place. If it does not go all the way back, remove it and

rotate the drive mechanism 1/4 turn. Then push the drawer back

again.

2) Throw away the first few batches of ice to allow the water line to

clear.

Be sure nothing interferes with the sweep of the feeler arm.

When the bin fills to the level of the feeler arm, the icemaker will

stop producing ice.

It is normal for several cubes to be joined

together.

If ice is not used frequently, old ice cubes will

become cloudy, taste stale and shrink.

Rotate

Drive

Mechanism

Feeler Arm

ICE BUCKET

ICE MAKER

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Keine Kommentare

Samsung RM25JGRS Bedienungsanleitung Seite 33