Samsung HPP5581X-XAA Bedienungsanleitung PDF herunterladen (Seite 14)

Remove the screws from the back of the PDP.

Connect insulation holders to screws (see the illustration below).

• If you are uncertain about installation, hire a specialist to install the wall mount bracket.

• Be sure to check that the insulation holders are completely secured on both the left

and right side after hanging the PDP on the wall mount bracket.

• Be careful to avoid getting your fingers caught during installation.

• Make sure the wall attachment panels are tightened. Otherwise the PDP may fall.

Note

•A 5 inch(12.7 cm) gap is needed between the back of the Plasma TV and the wall.

Wall Installation Instructions

Fixing the PDP panel to the wall attachment panel bracket

Tighten the screws of the insulation

holders to the back of the PDP.

Put the 4 insulation holders on the PDP

in the grooves of the wall mount

bracket and pull down on the PDP (Œ)

to secure it to the wall mount bracket

(´). Tighten the screws as shown (ˇ)

so that the PDP cannot be separated

from wall mount bracket.

PDP panel

Wall attachment panel

bracket

Wall

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 127 128

Keine Kommentare

Samsung HPP5581X-XAA Bedienungsanleitung Seite 14