(*1) Communication condition is specified by a.
(*2) Setting value is set by Function 11.
- Setting value is set by Function 11. It might differ from the current
communication condition before executing Function 2 or depending on the
setting of the DIP Switch.
- This function is used to confirm whether Function 11 ends normally before
executing Function 2.
5-635-62
GS ( E pL pH fn a <Function 12>
[Format] ASCII GS ( E pL pH fn a
Hex 1D 28 45 pL pH 0B a
Decimal 29 40 69 pL pH 11 a
[Range] (pL + pH x 256) = 2 (pL = 2, pH = 0)
fn = 12
1 ≤ a ≤ 4
[Description] Transmits the setting value of the serial interface communication condition
specified by a.
[Notes] This function works in user setting mode and during normal operation.
This function transmits "Header to NUL" as follows:
a
1
2
3
4
Communication condition
Baud rate
Parity
Flow control
Bit length
GS I
[Name] Transmit printer ID
[Format] ASCII GS I n
Hex 1D 49 n
Decimal 29 73 n
[Range] 1 ≤ n ≤ 3, 49 ≤ n ≤ 51, 65 ≤ n ≤ 68, n = 33
[Default] None
[Description] Transmits 1 byte of printer ID which is specified by n as follows:
[Notes] This function works in user setting mode and during normal operation.
This function transmits "Header to NUL" as follows:
[Notes] When you use this command, obey the following rules.
- When the host PC transmits the function data, transmit next data after
receiving the corresponding ID from the printer.
- With a serial interface printer, be sure to use this function when the host
can receive data.
- With a parallel interface printer, data (printer ID, printer information) sent
with this command is temporarily stored in the printer send buffer like other
transmitted data (except ASB). When the host goes into reverse mode, the
printer then sends the data sequentially from the beginning of the send
buffer.
Transmits printer information A (common information), using n as follows:
Transmits printer information B (common information), using n as follows:
Transmit data
Header
Identifier
Communication condition (*1)
Separator
Setting value (*2)
NUL
Hex
37H
33H
30H ~ 34H
1FH
30H ~ 39H
00H
Decimal
55
51
48 ~ 52
31
48 ~ 57
0
Data quantity
1 byte
1 byte
1 byte
1 byte
1 ~ 5 bytes
1 byte
n
1, 49
2, 50
3, 51
Printer ID
Printer model ID
Type ID
Version ID
Specification
Printer model
Printer type
Firmware version
n
33
Printer ID
Type information
Specification
Supported functions
n
65
66
67
68
Printer ID
Firmware version
Maker name
Printer model
Serial No
Specification
Firmware version
KPS
Printer model
Serial No of the printer
CONTROL COMMANDS LIST
CHAPTER 5
(6 Seiten)
(116 Seiten)
(107 Seiten)
(143 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern