
6
Installing the Hob
Be sure the new appliance is installed and grounded only by qualied personnel.
Please observe this instruction. The warranty will not cover any damage that may occur
as a result of improper installation.
Technical data is provided at the end of this manual.
Safety instructions for the installer
• With respect to re protection, this appliance corresponds to EN 60 335 - 2 - 6. This type of
appliance may be installed with a high cupboard or wall on one side.
• Drawers may not be tted underneath the hob.
• The installation must guarantee shock protection.
• The kitchen unit in which the appliance is tted must satisfy the stability requirements of
DIN 68930.
• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.
• On tiled work surfaces, the joints in the area where the hob sits must be completely lled
with grout.
• On natural, articial stone, or ceramic tops, the snap action springs must be bonded in
place with a suitable articial resin or mixed adhesive.
• Ensure that the seal is correctly seated against the work surface without any gaps.
Additional silicon sealant must not be applied; this would make removal more difcult when
servicing.
• The hob must be pressed out from below when removed.
WARNING
CTR41RCC_HAC_DG68-00287A-02_EN.indd 6 2014-03-13 �� 3:30:42
Kommentare zu diesen Handbüchern