Samsung SCR-3000 Bedienungsanleitung PDF herunterladen (Seite 62)

5-12

(3) TAPE SELECT

Set the tape length for accurate calculation of remaining tape time and precise control.

● SCR-3000N/SSC-Dual [T-120/T-160/T180]

● SCR-3000P [E-180/E-210/E-260]

(4) VCR BUZZER

Set the buzzer so that the VCR's status could be known. If there is a problem in VCR SYS-

TEM

Set it to ON to enable the BUZZER and to OFF to disable the BUZZER.

The buzzer will sound in the following cases.:

- If there is a problem in the VCR SYSTEM.

- If the tape reaches the end part or is in PRE END (when the remaining time is less than 5

minutes) during ARCHIVE.

- If there is no tape inserted, or REC Safety TAB is removed from the inserted tape when

you start ARCHIVE, or in TIMER ARCHIVE MODE. [ON/OFF]

(5) CHANNEL

CHANNEL is enabled if MULTIPLEXER is set to WITH and disabled if it is set to WITH-

OUT. If CHANNEL is enabled and you set it to SELECT, all channels recorded on the hard

drive will be displayed. If you set it to ALL, all channels will be set to ON and become tar-

gets for backup. [SELECT/ALL]

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 93 94

Keine Kommentare

Samsung SCR-3000 Bedienungsanleitung Seite 62