
Operation Manual
4-58
[Figure 4.18 Oblique View]
Oblique View Mode Menu
■
Single Static Line
View a surface image that is perpendicular to the default line in the image. Use the Angle dial-
button on the control panel to rotate the default line.
■
Dynamic Line
After drawing a straight line, view a surface image that is perpendicular to the line.
1. Draw a line by using the trackball and the Set button. The start point is shown as S and the
end point is shown as E.
2. Use the Change button to move the line. After moving the line to a desired position with the
trackball, press the Set button to conrm the new position.
3. Use the Angle dial-button or the Line Rotation dial-button to change the angle of the line.
Kommentare zu diesen Handbüchern